Environmental Hygienist Explains 10 Steps To Kill
Indoor Insects with High Output Ozone Gas
by Phillip Fry, Certified Environmental Hygienist and Certified Ozone
Dec. 12, 2013. Killing indoor insect pests such as dust mites, bedbugs, and
cockroaches is best done with high output ozone gas properly applied,
according to Phillip Fry, Certified Environmental Hygienist and Certified
“High output ozone gas is much safer for human occupants and their pets than
the use of the toxic chemical pesticides that often leave an unhealthy
product residue inside pesticide-treated homes, offices, and workplaces,”
notes Mr. Fry, who includes the following ten steps to kill indoor insects
with ozone gas on the EnviroFry website
1. Ozone gas is a regular, two oxygen atom molecule (0²) to which an extra
oxygen atom has been temporarily added by the ozone generator to create a
three oxygen atom molecule, (ozone gas) (0³). This extra oxygen atom gives
the molecule its ozone gas a very effective and powerful oxidizing power to
kill insects, mold spores, mold growth, and odors such as pet odors and
Ozone gas is regularly utilized by hospitals to sanitize hospital rooms and
operating rooms. Ozone gas is also rapidly replacing chlorine gas as the
preferred process to disinfect swimming pool and public whirlpool spa water.
2. No people, pets, or live plants can be inside the ozone-treated house,
condo, apartment, workplace, or commercial or governmental building during
the lengthy ozone treatment time sessions, or for two hours afterwards.
Bug-killing ozone gas returns to normal oxygen in about 30 to 45 minutes
after turning off the ozone generator.
3. So that ozone gas can reach all areas and surfaces in which the insects
can hide, take preparatory steps such as, but not limited to: (a) leave
dresser drawers, bathroom vanity drawers, kitchen cabinet doors and drawers,
and office desk and filing cabinet drawers open about two to four inches;
(b) remove all rugs from the floor and hang them on portable clothes drying
racks so that the ozone gas can treat both sides of the hanging rugs as well
as the now exposed flooring beneath where the rugs usually placed; (c)
remove and discard all accumulated newspapers, magazines, trash, and
wastebasket contents to outdoor trash bins or containers; (d) open closet
doors and drawers; (e) thoroughly clean and vacuum all floors and
upholstered furniture and the entire house or building; and (f) put clothes
on hangers two inches apart to allow ozone treatment on both sides of the
4. Protect your electrical and electronic possessions against any potential
damage from lengthy ozone treatment sessions by: (a) taping over (with wide
masking tape) all exposed rubber and vinyl items like the rubber gaskets of
refrigerators and freezers; and (2) removing all electronic items such as
computers, TVs, music systems, etc., from the building or covering such
items with plastic sheeting taped tight to keep the ozone from getting into
or onto the protected equipment.
5. Close all windows and doors except for leaving one window (located
relatively close to the running ozone generator) open about two to four
inches high to provide a source of fresh air for the ozone generator to turn
into ozone gas.
6. Leave the heating/cooling system off during the ozone treatment sessions
except when doing ozone treatment into the inside of
the home or building’s
heating, ventilating, and air conditioning (HVAC) equipment and ducts, in
which case, run the HVAC system on fan ventilation only (no heating or
cooling) to help move the heavy ozone gas throughout the HVAC ducts and the
entire house or building.
7. Use the high output (28,000
mg. of ozone output per
hour) contractor model Bio3Blaster (available at
www.ozonegeneratorkillsmold.com) because indoor insect killing requires
massive amounts of ozone gas for extended time periods, such as at least
eight hours into the return air duct of the operating HVAC system, plus at
least eight hours inside each separate room or area of the house, including
the basement, crawl space, and attic. If necessary, do additional ozone
treatment sessions daily for several days in a row to make sure all insects,
mold spores, and exposed mold growth are dead.
8. When doing ozone treatment of each room or area, use two large box fans
placed close to the outward ozone gas flow to move the ozone both vertically
and horizontally to counteract the natural tendency of the heavier-than-air
ozone gas to fall to the floor.
9. Use the General Electric timer or its remote control on-off switch (that
is provided with the EnviroFry ozone generator) to turn remotely turn the
ozone generator off and on.
10. During the ozone treatment time session, do not enter into the treatment
area without wearing a 3M brand breathing respirator with VOC filters and
rated P100 (minimizes your breathing in of ozone), about $40 from a large
home improvement or hardware store.
For questions about the use of ozone gas to kill insects, mold, and odors,
please visit the website
www.ozonegeneratorkillsmold.com, or email Phillip Fry
email@example.com, or phone Mr. Fry toll-free 1-866-300-1616, or
his cell phone 1-480-310-7970.